Product ID:ES270, ULTRAJET CO2 DUSTER
MSDS Date:06/01/1991
FSC:6830
NIIN:00N028524
MSDS Number: BMYBL

CHEMTRONICS INC

8125 COBB CENTER DR
KENNESAW, GA 30144
US

Emergency Phone: 404-424-4888;800-424-9300(CHEMTREC)

Info Phone: 404-424-4888

Preparer: M. WATKINS

Cage: 2M589

CHEMTRONICS INC (CANCELLED USE 21267)

HAUPPAUGE, NY 11760 US

Telephone: 770-424-4888/800-645-5244

Cage: 2M589

LIQ CARBON DIOXIDE @ EXTREMELY HIGH PRESSURE &

RTECS: 9999999ZZ

A COMPRESSED GAS CYLINDER. IN APPLIC WHERE TEMPS

RTECS: 9999999ZZ

OR OTHER MATLS WHICH BECOME BRITTLE AT LOW TEMPS. IN

RTECS: 9999999ZZ

THE ATMOSPHERE SHOULD BE TESTED WITH CARBON DIOXIDE

RTECS: 9999999ZZ

BY A PHYSICIAN.

RTECS: 9999999ZZ

CARBON DIOXIDE

CAS: 124-38-9

RTECS: FF6400000

OSHA PEL 5000 PPM

ACGIH TLV: 5000PPM/30000STEL;93

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL:GAS IS AN ASPHYXIANT. SYMP OF
OVEREXP VARY IN CONC RANGING FROM 1.5 % TO 10% & INCLUDE HDCH,
DYSPNEA, PERSPIRATION, TREMORS, VISUAL DISTURBANCE & UNCONS. UNCONS
CAN OCCUR WITHOUT WARNING AT CONC >10% PREVENTING SELF-RESCUE. AT
HIGH CONC CARBON DIOXIDE DISPLACES THE OXYGEN IN THE AIR BELOW
LEVELS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:NEC TO SUPPORT BRTHG. EYE: LIQ CNTCT
W/DESUBLIMED SOLID CAN CAUSE FROSTBITE. INGEST:INJURY UNLIKELY
SINCE MATL IS A GAS @ ROOM TEMP. INGEST OF DESUBLIMED SOLID COULD
CAUSE FREEZING OF MOUTH & THROAT TISSUES. SKIN:LIQ CNTCT
W/DESUBLIMED SOLID CAN CAUSE FROSTBITE. EXPOS SYMP: INHAL: BRTHG
HIGH CONC (SUPP DATA)
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY PROBLEMS;
CARDIOVASCULAR DISEASE.

First Aid:INHAL:REMOVE TO FRESH AIR & CALL MD. IF NOT BRTHG, GIVE ARTF
RESP, PREFERRABLY MOUTH-TO-MOUTH. IF BRTHG DFCLT, GIVE O2. EYE:SAME
AS FOR CYROGENIC BURNS OF SKIN. IMMED FLUSH W/POTABLE H2O FOR A
MINIMUM OF 15 MIN. SEEK ASSISTANCE FROM MD INGEST:SAME AS FOR
CYROGENIC BURNS OF SKIN. GET MD IMMED . SKIN: SOAK FROZEN TISSUES
IN TEPID H2O. DO NOT USE HOT H2O! CYROGENIC BURNS (SUPP DATA)

Flash Point Method:TOC
Flash Point:NONE
Lower Limits:NON FLAMM
Upper Limits:NON FLAMM
Extinguishing Media:NONFLAMMABLE. EXTINGUISHING MEDIA SUITABLE FOR
SURROUNDING FIRE .
Fire Fighting Procedures:NONE KNOWN. WEAR NIOSH/MSHA APPROVED SCBA AND
FULL PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:PRESSURIZED MINI-CYLINDERS MAY VENT,
RUPTURE OR EXPLODE AND ADD TO FLYING AND FALLING DEBRIS.

Spill Release Procedures:VENT AREA. IN SMALL QUANTITIES CARBON DIOXIDE
WILL DISSIPATE LEAVING BEHIND CARBON DIOXIDE 'SNOW'. AVOID CONTACT
WITH COLD VAPORS. GAS WILL REMAIN IN LOW AREAS WITHOUT ASSISTED
VENTILATION.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE NEAR SOURCES OF HEAT, IN
DIRECT SUNLIGHT, OR WHERE TEMPERATURES EXCEED 150F. DO NOT PUNCTURE
OR DAMAGE CONTAINERS. ROTATE STOCK.
Other Precautions:STORE LRG QTYS OF CYLINDERS IN WELL VENT AREA. AVOID
EXPOS TO AREAS WHERE SALT/OTHER CORROSIVE CHEM ARE PRESENT. PVNT
CNTCT W/ LIQID CARBON DIOXIDE 'SNOW'. USE ONLY IN WELL VENT AREAS.
COMPRESSED GAS MINI-CYLINDERS CNTN GASEOUS & (ING 3)

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR IF > TLV.
Ventilation:MECHANICAL IN LOW PLACES.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NORMAL VENT FOR STANDARD MANUFACTURING PROC IS
GENERALLY ADEQ. LOCAL EXHST SHOULD BE USED WHEN LRG AMTS ARE
RELEASED.
Supplemental Safety and Health
EFTS OF OVEREXP: OF VAPOR CAN CAUSE HDCH, DYSPNEA, PERSPIRATION,
TREMORS, VISUAL DISTURBANCE AND UNCON. EYE/SKIN: CAN CAUSE
FROSTBITE IF EXPOSED TO DESUBLIMED SOLID. INGEST: BURNING OF THE
LINING OF T HE MOUTH AND THROAT. FIRST AID PROC: WHICH RSLT IN
BLISTERING OR DEEPER TISSUE FREEZING SHOULD BE IMMED SEEN (ING 2)

HCC:G3
Boiling Pt:B.P. Text:-109F,-43C
Melt/Freeze Pt:M.P/F.P Text:-109F,-43C
Vapor Pres:831 @ 68F
Vapor Density:0.115 @68F
Spec Gravity:68.74 (H2O=1)
Evaporation Rate & Reference:< 1 (BUTYL ACETATE=1)
Solubility in Water:87.8 @ 68F.
Appearance and Odor:CLEAR, COLORLESS, ODORLESS GAS.

Stability Indicator/Materials to Avoid:YES
MATERIALS MUST BE ABLE TO RESIST CARBONIC ACID, IF MOISTURE IS PRESENT.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE.

Waste Disposal Methods:HAVE UN-USED CYLINDERS REMOVED BY A TSD FACILITY
EQUIPPED TO HANDLE DISPOSAL OF HIGH PRESSURE GAS CONAINERS.
DISPOSAL MUST BE IN ACCORDANCE WITH FEDERAL, STATE AND LOCAL
REGULATIONS .

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.